【请登录】【免费注册】

上海兆恬实业有限公司

天眼查

主营:PP免处理油墨,自干金属油墨,免烘烤金属油墨,丝印金属油墨,PE油墨,烤漆面金属油墨,耐高温陶瓷油墨,耐高温玻璃油墨,尼龙加玻纤油墨,物质材料板油墨,UV丝印油墨,UV移印油墨,电镀表面油墨,自干五金油墨,自干不锈钢油墨,自干铝合金油墨

  • 中玻跨境
商铺导航
联系我们

+详细

  • 公司名:上海兆恬实业有限公司
  • 地址:上海 上海 嘉定区西冈身路777号
  • 邮箱:zhao445850506@qq.com
  • 联系人:杨先生
  • QQ:
留言咨询
上海兆恬实业有限公司 > 化工原料、辅料 > 无卤素玻璃丝印油墨

无卤素玻璃丝印油墨

  • 无卤素玻璃丝印油墨
  • 订货量(公斤)

    价格(不含税)

  • 1

    220.00元/

  • 10

    200.00元/

  • 20

    180.00元/

  • 供应标题:无卤素玻璃丝印油墨

    价格:电仪

    发布公司:上海兆恬实业有限公司

    供货总量:10000000

    联系人:杨先生

    发货地点:上海 上海 嘉定区

    发布时间:2023年08月14日

    有效期至:2024年02月12日

    在线咨询:

    在线询盘:在线询盘

    产品综合信息质量:未计算

温馨提醒:请消费者做好对国际包裹的防疫措施,商品需要有进口物品三证一报告(供货者许可证、入境检疫证明、预防性消毒证明和新冠病毒核酸检测报告)

查看更多同类产品

品牌:欧莱斯
  • 适用对象:金属,玻璃,陶瓷,电镀,五金,不锈钢,铝合金,拉面板,烤漆面,喷漆面,喷塑面,喷粉面
  • 单件净重:1公斤
  • 着色力:100
  • 细度:0.01
  • 粘度:1500S
  • 流动度≥:100
  • 保质期:72个月
  • 型号:MPL
  • 用途:各种金属、玻璃、真空电镀、水电镀、电泳、阳极氧化铝、电解板、铝塑板、喷塑、喷粉、静电喷漆面、烤漆面以及各种天花吊顶氧化板、镜面板、覆膜板、辊涂板等制品的丝印及移印
  • 英文名: scope of application: iron, aluminum, alloy, glass, ceramics, electroplating, stone, anodic alumina surface and baked (spray paint thinner: 2) with the company S-03 diluent 3 curing agent: can add TA-9154 hardening agent 10% increase adhesion, improve the ink film hardness.
  • 耐温性:高温玻璃油墨
  • 性能:自干玻璃漆
  • 性能:可在玻璃上进行印刷并能牢固附着的油墨。

    用途:广泛用于建筑幕墙、汽车玻璃、炉灶烤箱面板等;

    英文名:Glass ink

    相关推荐:汽车玻璃油墨高温玻璃油墨钢化玻璃油墨玻璃油墨

    基本信息

    本产品是采用高级进口丙烯酸树脂和高级颜料经过细制研磨加工组合而成,用于各种金属、玻璃、陶瓷、石材、电镀(含水电镀)、阳极氧化铝表面及烤(喷)漆面等制品的丝印及移印,不需加固化剂,不需烘烤,即可获得的附着力。

    油墨特性:

    1、平光、附着力佳、耐汽油、耐化学品;

    2、手感好,流平性佳、面光洁;

    3、表面硬度好,耐冲击性能强、抗刮伤;

    4、耐汽油、耐酒精、耐化学品程度佳;

    印刷:

    选用网目为100-350目,以120T网纱计算涂覆盖面积每公斤达30~35㎡。

    表干时间自然挥发5-15分钟,实干时间在24小时以内,48小时后达较佳性能。

    1.用配套专用稀释剂开油水

    2.用718洗网水洗网。

    3.或添加配套硬化剂10%可增加附着力,提高墨膜硬度。

    4.烤箱80℃烘烤10分钟佳能更优。

    测试方法(完全干燥后):

    1.3M胶纸粘在画有百格的油墨表面45度角迅速拉起不脱油。

    使用方法:

    1.建议用我公司专用稀释剂进行稀释,不建议使用783慢干稀释剂稀释,使用前应充分搅拌,用后随时密封。

    2.搅拌时加本公司配套开油水10-12%,稀释到印刷适合粘度,移印稀释使用移印专用稀释剂;用718洗网水清洗。

    3.不得与其它类型油墨混合使用,否则容易出现其他附着力,化学反应等不良现象。

    4. 加入固化剂的油墨使用时限为8小时,过期请弃用,剩余油墨不可回收

    注意事项:

    1.各种承印物料的外观相似,但可能会是不同的材料,客户需先试印,确其符合要求后,再批量生产。

    2.在移印过程中,如出现拉丝或散开,可适当加入一些慢干膏即可;

    3.环境温度过高,将会影响油墨原有质量。白色超越150都会变色,烘烤时请用木质材料垫底进行烘烤,不得直接接触铁

    4.根据气候变化,请远离火源,阴暗处15度-30度环境下存放

    Brand: but MY name: anodic oxidation INK Numbers: 65496

    Anodic oxidation ink series

    The product is produced with advanced import acrylic resin and senior pigment after fine grinding system, used in combination to ABS, PP, PET, all kinds of metal, glass, ceramic, stone, electroplating (water cut electroplating), anodic alumina surface and roast (spray paint products of screen and pad printing, not needing curing agent, and does not need to bake, can obtain excellent adhesion.

    Ink characteristics:

    1 the classification includs glass, adhesion, good resistance to gasoline, alcohol, resistance to chemicals;

    2, feel is good, flow ping sex, good surface is bright and clean;

    3 and fine surface hardness, impact resistance properties of strong, resistance to scratch;

    4, resistant to gasoline, alcohol, resistant to chemicals resistant degree good;

    Printing:

    Choose for 100-350 mesh mesh to 120 T nets yarn with coverage area calculation per kilogram of 30 to 35 ㎡.

    Dry time table natural volatilize 5 to 15 minutes, action in time within 24 hours, after 48 hours of optimum performance.

    1. With matching special thinner, open oil and water

    2. Wash washing nets with 718 net.

    3. Or add hardener 10% supporting can increase adhesion, improve ink film hardness.

    4. Preheat the oven to 80 ℃ bake for 10 minutes Canon even better.

    Test method (dry) :

    1.3 M tape stuck in the picture has's ink surface 45 degree Angle quickly pull up not to take off oil.

    2. The purity of 99% alcohol 500 G force in ink surface wipe 300 times back and forth without decoloring.

    Method of use:

    1. The proposal with my company special thinner to dilute, not recommended dry thinners diluted 783 slow, before the use should be fully mixing, use at any time after sealing.

    2. Add the company supporting stirring open 10 to 12%, oil and water dilute the printing for viscosity, pad printing dilution use moving printing special thinner,; Use clean water to wash the nets 718.

    3. Not with other kinds of printing ink mixed use, otherwise easy to have other adhesion, chemical reactions and other bad phenomenon.

    4. Add hardener inks use time limit for 8 hours, please not used, the remaining expired ink not recycling

    Note:

    1. All kinds of printing material appearance similar, but may be of different material, customers are required to meet the requirements of the ShiYin, indeed, its, then batch production.

    2. In moving printing process, such as a wire drawing or away, can be appropriately to add some slow dry paste can;

    3. Environmental temperature is too high, will influence the quality of the original ink. White will change color, roasted beyond 150 when please use woodiness material bottom, and may not directly contact roast iron

    4. According to climate change, please away from fire, the shadows 15 degrees-30 degrees environment for

    020.jpg100.jpg100.jpg022.jpg20151225104908_0095.jpg

    上海兆恬实业有限公司基本信息

    主营产品:PP免处理油墨,自干金属油墨,免烘烤金属油墨,丝印金属油墨,PE油墨,烤漆面金属油墨,耐高温陶瓷油墨,耐高温玻璃油墨,尼龙加玻纤油墨,物质材料板油墨,UV丝印油墨,UV移印油墨,电镀表面油墨,自干五金油墨,自干不锈钢油墨,自干铝合金油墨 公司成立年份:2017
    公司网址:http://sh18201776975.glass.com.cn

    无卤素玻璃丝印油墨


    产品属性:
    计量单位:公斤 供货总量:10000000 最小起订量:1 产品单价:220.00 品牌: 规格型号: 包装说明:

    无卤素玻璃丝印油墨产品概况

    按加工温度分
    其他供应

    我要评论

    诋毁、恶意攻击、无事实依据、非正能量的消极评语会被管理员删除,您的评语可能对其他人有很高的参考价值。

    相关评论

    好评
    0%
    中评
    0%
    差评
    0%

      关于本网| 大事记|玻璃展会|热点搜索|玻璃人才|玻璃名录|站点地图|活动推广|隐私声明|版权声明|玻璃供应|联系我们|English

      中玻网 版权所有 © 2001-2023 邮箱:Service@glass.com.cn 在线沟通:

      本网中文域名:玻璃网.中国 本站网络实名:中玻网-中国专业的玻璃行业信息网站

      浙B2-20060159